Strength · Programming · Getting started · 6 min read · Updated November 2026

How to Warm Up Before Lifting Weights: The First 10 Minutes

Here's how to warm up before lifting weights without wasting the session on it: about five minutes of easy movement to get warm, then three to five lighter sets of the first lift you're doing, climbing to your working weight. That's it. A warm up isn't stretching and it isn't cardio. It's the first set of the thing you're about to do, done light, so that the set you actually care about starts right. It's the same idea behind how our beginner programmes teach every movement light before any weight goes on, and it never really stops applying.

What the warm up is actually for

Two jobs. The first is temperature: muscle that has been sitting in a car or at a desk works better once it is warm, and a few minutes of anything that raises your breathing a little handles that. A bike, a rower, brisk walking, a couple of rounds of skipping. You're not training here. If you're sweating hard at minute five you went too far.

The second job is rehearsal, and it matters more. The first rep of a squat each session is a slightly different squat from the last one: different stiffness, different sleep, a different day. Lighter sets let your body find the groove again before the bar is heavy enough to punish a sloppy rep. That's why the warm up should look like the lift. Ten minutes on a treadmill gets you warm and teaches your squat nothing.

Warm up sets: how many, and how heavy

The rule we'd give anyone is that the warm up sets get heavier and shorter as they go, and none of them should tire you. The point is practice at rising loads, not volume.

Say your working sets today are 5 reps at 185 pounds on the squat. A reasonable ladder looks like this: the empty 45 pound bar for 8 to 10 easy reps, then 95 for 5, 135 for 3, and 165 for 1 or 2. Then 185 for your real sets. Four warm up sets, maybe 20 total reps, and the heaviest of them only a couple of reps long so it costs you nothing.

Lighter working weights need fewer steps. If you're squatting 95, the bar and one jump in between is plenty. A heavier lifter needs more, because the gap between the empty bar and the top set is bigger and you don't want any single jump to feel like a surprise.

Only the first lift of the day needs the full ladder. By the time you get to your second or third exercise you're warm, and one or two lighter sets to find the movement is enough.

Where stretching fits, if anywhere

Long static holds right before heavy lifting are the one thing we'd move. A meta-analysis by Simic, Sarabon and Markovic in the Scandinavian Journal of Medicine and Science in Sports (2013) pooled the research on stretching before exercise and found that static stretching reduced maximal strength by about 5.4% on average, with the effect smaller when each stretch was held for 45 seconds or less.

So a short hold on something that's genuinely tight, just to get into position, is fine. A 15 minute stretching routine before a heavy day is spending time on something that pulls slightly the wrong way. Save the long holds for after the session or a separate day if you like them. Leg swings, a few bodyweight squats and some arm circles get you moving through range without that tradeoff.

Foam rolling we'd treat the same way. If two minutes on a stiff spot helps you get into position, do it. It doesn't replace the lighter sets.

Cold mornings and early sessions

This time of year a lot of people train before work, in a garage or a gym that hasn't heated up yet, straight out of a night's sleep. The answer is the same warm up with the first part stretched out a little: give the general warm up a few more minutes until you're actually warm, then run the same ladder. Don't add more heavy warm up sets. Add more easy minutes at the start.

The same goes for anyone who's sat all day before an evening session. A desk doesn't change what the warm up is. It just means the first few minutes deserve a bit more patience before the bar gets loaded.

Lifters coming back to training after a long break, and most people over 40, tend to do better with a slightly longer ladder: one or two extra steps so the jumps are smaller. It's the same thinking our strength after 40 programmes use for the working sets, small increases and a couple of reps left in the tank, applied to the first ten minutes.

The mistake we see most

Skipping the ladder and doing one set with the empty bar before jumping straight to the working weight. It feels efficient. It's actually the slowest option, because the first working set becomes the real warm up, it moves worse than it should, and the session is half over before the lift feels right.

The opposite mistake is rarer but real: a warm up so long and so tiring that the working sets are done on a tired body. If your warm up has more total reps than your working sets, trim it.

When we coach someone in a private session, the warm up sets are where a lot of the coaching actually happens. It's the cheapest place to fix a squat, because a bad rep at 95 pounds costs nothing. If you want someone to build that ladder with you, it's part of every session at our Brick Township studio, and the way to start is to book a session. For how the working sets should climb from week to week after that, see our piece on progressive overload.

Ready to start?

One conversation: your history, your goal, your schedule. No pitch, no pressure.

Book a session

Keep reading

Call Coach Eric · (732) 278-6618